If your clock stops working open the battery compartment on the back of the clock to remove the old battery.
Wall clock hands not working.
Push the hour hand against the clock shaft.
Cheap clocks usually just have a generic plastic clock attached to the back.
Use a damp q tip or cotton ball to gently wipe down the terminals then dry them with a clean cloth or towel.
A replacement should run you a few dollars.
Friction holds the hour hand on the shaft and.
The hour hand is held to the shaft via friction.
A small push can give it the connection it needs to get back in time with the second hand.
If the clock hands are touching that may be the reason the clock stopped moving.
Bend the hour or minute hand whichever is on top slightly toward you to create clearance.
Open the clock face and inspect the clock hands.
In two minutes artist and clockmaker pamela corwin shows you how to address a wall clock with non moving hands.
Push the hour hand back and forth gently to release it.
Make sure the clock hands are properly seated on the clock shaft and not catching on each other.
Have a look and see if you can open it up remove the hands from the shaft and remove the clock itself.
Hold the second hand and tighten the tiny nut at the end of the shaft with needle nose pliers.
When battery operated clocks stop working it s usually caused by one or more of the batteries.
If the pendulum is not swinging be sure the pendulum is hung from front to back and that the clock is flush to the wall.
If you have a bike chain desk clock 26f try re seating the battery.
Often the internal mechanisms such as the cogs springs and other movements of the clock are not faulty and are unaffected.
The hands aren t moving.
This problem is usually caused by set.
If the hands on your clock refuse to remain tight you may need to replace the nut or the clock hands.
In other words take the battery out and put it back in making sure it is nicely seated.
If it s simply a matter of tightening the hands push the hour hand against the clock shaft first.
You can likely replace the actual clock itself keeping the frame faceplate and hands.